I’m working on a linux practice test / quiz and need a sample draft to help me understand better.(Complete ‘Printer Configuration’ Part and Answer Format may be PDF and code screenshot) We use proxmox on class.Thanks a lot!!Modules, Network card and print utilitiesNormally to configure you network card that is not working you need to insert the module (driver) that pertains to your network card.This can be done with the insmod or modprobe command.To see which driver you are currently using, you can use lsmod.This concept is the same for all devices.Some of your installations will already have a default driver installed, otherwise it needs to be downloaded from the manufacturer.You can also use a command called dmesg.This will show you messages that the kernel is putting out.This can be very useful when determining problems with devices in your system If you are not sure what card you have, you can use lspci.This will list the Plug and Play (PnP) IDs for all of the devices in your machine.The network card is usually listed and a network controller or something similar.You can use the Internet to search the PnP ID, you should just search the Ven and Dev.After you have it on your machine you can use tar and gzip to extract it; often times the extraction contains instructions (readme.txt, install.txt, etc) on how to install it.Your distributions also contain a setup utility (setup) to modify the card configuration from the command line.You can also use network setup in the GUI.Remember, to start x-windows from the command line, you can type startx. After the NIC is working, you can use setup to configure networking and ifconfig to modify parameters. Please remember to ‘man’ insmod, modprobe, lspci, tar, gzip, dmesg and lsmod. These are examples, NOT something you should do: ifconfig eth0 up|down ifconfig eth0 204.32.168.56 Broadcast 204.128.244.127 Netmask 255.255.255.0 or ifconfig eth0 192.168.10.25 If your network card is working, you should be able to ping the Internet; How do you set your NIC to do DHCP Client from the command line?What program is responsible for doing this? Printer Configuration: In order to configure your printer, you should run setup and choose printer configuration.This will modify the /etc/printcap file.You should look at this before and after printer configuration. This IP Address of the printer is 192.168.0.2; also you can use an HP LJ4100 driver for this printer.You can make a virtual printer using CUPs below by created a PDF printer You should also look at the following commands.Test them out and look at the man pages pertaining to them.Do not forget to try redirecting output to and from some of these! lpr lpqlprmlpc Another popular method from configuring printers with a GUI interface is CUPs.You may have to install CUPs using apt-get (sudo apt-get install cups).Cups uses a web interface you can access from another computer, however you made need to mod your cups.conf to allow access from other than your local machine! After you get cups installed you may want to check its status ‘/etc/init.d/cups status’ (like all services running you can do this: /etc/init.d/
.pdf file
The post I’m working on a linux practice test / quiz and need a sample draft to help me u appeared first on Essay Desk.