For faster services, inquiry about  new assignments submission or  follow ups on your assignments please text us/call us on +1 (251) 265-5102

WhatsApp Widget

ENGR4035 Simulate the system shown in Fig 9.1 using Multisim. Initially set the Variable voltage source VB=1.5V: Basic Electrical Engineering Assignment, OBU, UK

Part A: (30%)
Simulate the system shown in Fig 9.1 using Multisim. Initially set the Variable voltage source VB=1.5V, and ‘open’ the switch and leave it ‘open’. Not an ‘open switch’ is not conducting and a ‘closed switch’ is conducting.

When you open the switch the LED should remain ON, then after a short interval go off. Repeat this sequence by momentarily closing the switch then opening it again. Note that almost instantly the switch is closed the LED comes ON.

Q1. Monitor and record the voltages at pins 2 and 3 of U1, keeping an eye on the LED status. At what voltage on pin 2 does the LED go out? Can you explain why it is no longer ON? Check and record the voltage changes at pin 6 of 741 op-amp (U1) when the LED is ON and OFF.

Q2. Set VB=2V, 4V, 6V and 8V . What happens to the LED for each value and why? Explain what U1 (741 op-amp) is doing?

Are You Looking for Answer of This Assignment or Essay

Pay & Buy Non Plagiarized Assignment

The post ENGR4035 Simulate the system shown in Fig 9.1 using Multisim. Initially set the Variable voltage source VB=1.5V: Basic Electrical Engineering Assignment, OBU, UK appeared first on Students Assignment Help UK.

WhatsApp
Hello! Need help with your assignments?

For faster services, inquiry about  new assignments submission or  follow ups on your assignments please text us/call us on +1 (251) 265-5102

Submit Your Questions to Writers for FREE!!

X
GET YOUR PAPER DONE