Uncategorized

1. Describe three ways to turn the crankshaft. 2. What is installed on rod bolts to protect the crank when removing the piston and rod assembly?  3. If non-roller lifters will be used again, what caution is necessary?

Technician A says that some crankshaft sprockets slide easily onto the crankshaft snout. Technician B says that some crankshaft sprockets are pressedfit. Who is right? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B

 Technician A says that it is usually easier to remove the engine with the automatic transmission on a rear-wheel drive car. Technician B says to disconnect the positive battery cable first. Who is right?  a. Technician A only              b. Technician B only c. Both A and B                       d. Neither A nor B

Technician A says that an automatic transmission heat exchanger is often located within the radiator. Technician B says that an automatic transmission heat exchanger is often found in the bottom of a radiator. Who is right? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B

Technician A says that a freewheeling engine is one that does not slow the vehicle down when decelerating. Technician B says that a freewheeling engine is one in which the valves cannot contact the pistons if the timing chain or belt breaks. Who is right? a. Technician A only     b. Technician B only c. Both

 Technician A says to check the cylinder bores for size, taper, and out-of-round wear. Technician B says to check the crankshaft journals for size, taper, and out-of-round wear. Who is right? a. Technician A only             b. Technician B only c. Both A and B                       d. Neither A nor B

Technician A says that when using a flare-nut wrench, two wrenches must often be used. Technician B says to use an open-end wrench on fuel fittings. Who is right? a. Technician A only       b. Technician B only c. Both A and B                d. Neither A nor B

1. If a hot spray cleaner is run when the cleaning temperature is not high enough, what can happen to the cleaning solution? 2. How can a metal be tested to see if it is ferrous or nonferrous?  3. Be sure to _________ machined areas of ferrous metals after hot-tanking.

1. An overhead cam (OHC) head has oil galleries. This makes it impractical to clean these heads with a glass bead _________. 2. What is another name for the airless blaster? 3. What is another name for a bake oven?

1. If the nozzle of a bead blaster is aimed at the window, it frosts the _________. 2. Glass beads are safe to use for cleaning because if they get into the oil they will not cause any damage. True or false?